IR440 GPS SENSOR TO PULSE
Item Description
IR440 GPS SENSOR TO PULSE
GPS speed sender to be used on most types of electronic tripmeters such as Terratrip, Brantz, Belmog classic etc.
This little black box makes it possible to use an electronic tripmeter without the need to install a cable or wheel probe and to change it to another car without the need to re-calibrate.
Not to be confused with a ‘normal’ GPS receiver, this instrument is very accurate tracking 50 satellites simultaneously! And can send over 8.000 pulses to a Terratrip in one minute!
It can also to be used to send pulses to an electronic speedo,
This clever device translates the GPS signal reception to 9.1 V pluses.
It can be used as a sensor for most electronic Tripmeters such as Terratrip, Brantz, Belmog classic etc.
The receiver/sender is 6,5cm x 5cm x 2cm.
This little black box needs to be simply mounted on the dashboard or the rear window sill.
Normally only three of the four wires need to be connected to be used on a tripmeter.
RED INPUT VOLTAGE 6V TOT 36V
BLACK GROUND (OV)
BLUE TO PULSE CONNECTOR OF TRIPMASTER
GREEN normally not used
Performance Specifications
- Pulse rate: variable (1000ppk to 10 000ppk) or fixed 2000, 4000, 8000, 50,000
- General: 56 channel tracking receiver, battery backup 12days
- Update rate: 10Hz
- Accuracy, horizontal: < 5m (50%), < 8 (90%)
- Accuracy, altitude: < 10m (50%), < 16 m (90%)
- Accuracy, velocity: < 0.06m/sec = 0.22km/h
- Acquisitions, after loss of lock: < 2s (90%)
- Acquisitions, first time power applied: < 38s (50%), < 42s (90%)
- Acquisitions, temporary loss of power: < 10s (50%), < 13s (90%)
- Operational limits, altitude: 18000m
- Operational limits, velocity: 300km/h
Electrical Characteristics
- Input voltage: 6V to 36V
- Power consumption: 240mW (12V, 20mA)
- Battery backup: 12 days
- Output pulse: peak to peak voltage: 5V, DC 2.5V
- Output pulse: maximum current drain: 25mA
Physical Characteristics
- 50mm (L), 67mm (W), 21mm (H)
